OTHER

Timber

With uncontrolled storage comes the high risk of oxidisation and it is therefore essential to control and reduce humidity. Storage of such equipment as steel at the correct humidity is critical and can often reduce the requirement for additional surface protection systems whilst in storage.

Providing the correct environmental conditions to preserve these items is vital and Calorex’s range of powerful dehumidifiers offer the ideal means of preserving and protecting them from humidity damage. They are equally suitable for humidity control in warehouses, castles and historic buildings where excess humidity is a significant problem without a professional dehumidification solution.

How a Calorex dehumidifier works

The high-performance dehumidifiers recirculate the air and physically remove moisture from it. This alleviates the need to continuously reheat incoming air. Not only that, the units convert energy taken out of the room as moisture to provide useful heat to warm the room, accelerating the drying process.

Effective dehumidification provides maximum protection in museums and historic buildings where priceless exhibits and artefacts are stored. For example, if the relative humidity is too high, condensation can form on surfaces and mould and rot can set in, and the rising and falling of humidity levels can cause degradation. This can, however, be avoided by maintaining the relative humidity at both correct level, and importantly at a stable level. Their functionality and easy operation make them ideal for large period properties, museums and archives and anywhere where preservation is vital.

Cost savings

Typically, as a by-product of the dehumidification process, for every unit of energy that a Calorex dehumidifier consumers, it will convert 2.5 times this amount to useable heat. The potential energy savings are huge. In fact, compared to using heating to try and control humidity levels, cost savings of 500% are not unusual. The units have built in humidity control, so will never waste energy when the correct humidity is reached, and there is no possibility of drying out the space too much.

Installation

Calorex dehumidifiers have a flexible design and are fully packaged, easy to install and can operate efficiently over an ambient air temperature range of between 0 and 40°C.

The Dantherm Group manufacture dehumidifiers in a range of sizes to suit any space. Whatever you need, Calorex, Dantherm Aerial and Master have the solution.

All products are supported by an in-house applications department and nationwide service network.

Associated products

High capacity DH150/300/600

DH 150AX-150BX

The DH 150 high capacity floor standing dehumidifier is self contained with fully automatic… ...read more

DH 300BY

The DH 300 high capacity floor standing dehumidifier is self contained with fully automatic… ...read more

DH 600BY

The DH 600 high capacity floor standing dehumidifier is self contained with integral, fully… ...read more

More information

Northwood Forestry

A dehumidifier from Calorex...read more

Dantherm Group

Commercial/Industrial Catalogue...read more


Contact (UK)

Jeremy Neale

Jeremy Neale

Commercial Dehumidification
Direct: +44 (0)1621 878 534
Mobile: +44 (0)7432 744 722
Contact Jeremy


Contact (International)

+44 (0)1621 856 611
International Enquiries


Share on Facebook Tweet Pin it Send email Print page
Other
  • linkedin
  • youtube