With uncontrolled storage comes the high risk of oxidisation and it is therefore essential to control and reduce humidity. Storage of such equipment as steel at the correct humidity is critical and can often reduce the requirement for additional surface protection systems whilst in storage.

Providing the correct environmental conditions to preserve these items is vital and Dantherm Group’s range of powerful dehumidifiers offer the ideal means of preserving and protecting them from humidity damage. They are equally suitable for humidity control in warehouses, castles and historic buildings where excess humidity is a significant problem without a professional dehumidification solution.

How a dehumidifier works
The high-performance dehumidifiers recirculate the air and physically remove moisture from it. This alleviates the need to continuously reheat incoming air. Not only that, the units convert energy taken out of the room as moisture to provide useful heat to warm the room, accelerating the drying process.

Effective dehumidification provides maximum protection in museums and historic buildings where priceless exhibits and artefacts are stored. For example, if the relative humidity is too high, condensation can form on surfaces and mould and rot can set in, and the rising and falling of humidity levels can cause degradation. This can, however, be avoided by maintaining the relative humidity at both correct level, and importantly at a stable level. Their functionality and easy operation make them ideal for large period properties, museums and archives and anywhere where preservation is vital.

Cost savings
Typically, as a by-product of the dehumidification process, for every unit of energy that a our dehumidifier consumers, it will convert 2.5 times this amount to useable heat. The potential energy savings are huge. In fact, compared to using heating to try and control humidity levels, cost savings of 500% are not unusual. The units have built in humidity control, so will never waste energy when the correct humidity is reached, and there is no possibility of drying out the space too much.

Our dehumidifiers have a flexible design and are fully packaged, easy to install and can operate efficiently over an ambient air temperature range of between 0 and 40°C.

The Dantherm Group manufacture dehumidifiers in a range of sizes to suit any space. Whatever you need, Calorex, Dantherm, Aerial and Master have the solution.

All products are supported by an in-house applications department and nationwide service network.

Associated products

Dehumidification, wall mounted compact dehumidifier OTW15

DH 15

Wall mounted compact dehumidifiers designed to fit in any size space more

CDF 40

Dantherm’s CDF range of powerful dehumidifiers CDF 40-50-70 provides the ideal means of… more

Wall-hung DH30/60

DH 30

Calorex heat pump dehumidifiers are designed for operation in low and high ambient more

CDF 50

Dantherm’s CDF range of powerful dehumidifiers CDF 40-50-70 provides the ideal means of… more

CDF 70

Dantherm’s CDF range of powerful dehumidifiers CDF 40-50-70 provides the ideal means of… more

High capacity DH150/300/600

DH 150AX-150BX

Our wide range of units and operating temperatures ensure there is a system to fit every more

Danx AF

The DanX AF is a highly efficient heat pump dehumidification system more

AA 300-500

The AA 300 and AA 500 are advance premium heat pump based dehumidification more

Case studies & brochures


When leading aerospace component more

Northwood Forestry

A dehumidifier from more

Dantherm Group

Commercial/Industrial more

Contact (UK)

Jeremy Neale

Jeremy Neale

Commercial Dehumidification (Phone) 01621 856611 (Mobile) 07432 744722
Contact Jeremy

Contact (International)

+44 (0)1621 856611
Contact Export

Share on Facebook Tweet Pin it Send email Print page
Storage, museums & archives
Subscribe to newsletter
Dehumidifier sizing tool
  • linkedin
  • youtube